gas ram help!

[matt007]

I wonder if there is someone out there that can help me with this....

I picked up a very nice .22 Fenman the other day but its running at a very low 6.5fpds! I dont have an adapter or a hand pump (i use a 3l 300bar tank for my pcp's)

Is there anyone local to me Haywards Heath area that knows about Theobens. not expecting a ''freebe'' and it might be a good time to service it ?

Tb1500 something is the serial number and it doesn't look like its ever been taken apart before.

Anyone...

[Shed tuner]

Is it very easy to cock.... ?
If so, might just need a pump. If not, might be the seal...

[matt007]

Hi jon, yes its easy to cock and virtually recoil less and almost silent!

[Shed tuner]

Well, if you get stuck I have the means to pump it up, but I'm about an hour from you...

[The Squire]

As Jon says it might just need a bit more air and happy days! Nice purchase too!!

[matt007]

Saying that Jon, its not as east to cock as my HW97k? but i presume it shouldn't be due to its barrel being 10 inch to the pivot point, it still feels ''easy'' to cock and i am not a body builder its a little like a compound bow being hard at the beginning and then easier at the end!

How hard is it to get a service kit for one? and what would one cost do you recon?

high end springers (and gas rams) are new to me as i have always had pcps apart from my first guns and a repetitively recent TX200SR my dad has a fenman in .20 and it felt a lot harsher than this

[secretagentmole]

Get it tested over a chrono, Best Fittings sell the adaptors!

[matt007]

Hi i did test it over a chrono, its 6.5fpds i would rather not buy a pump as its not like i have loads of theobens and prob only need to use it once. I would rather buy someone a drink and use theirs or pay for it to be serviced locally if there are any theoben boffins in Sussex area...?

[matt007]

To the gentleman who offered a little assistance from (Haywards Heath) who I was going to call.... i just deleted your message (your number) by mistake when my PM box was full! could you pm me it again.Thanks m.... it was Nigel i think?

[Tony.T]

I know Nigel very well!

He'll look after you- if you need his contact details let me know.