There was a bloke taking over where UK Neil left off, not heard much since though ?
Is there anyone on this forum who can make a simple brass collar for me?
Dimensions are approx. OD 30 mm, ID 22.5 mm, width of collar 6mm. 1 mm chamfer on OD, both sides/
Exact dimensions (need to double check the inside diameter) will be posted if anyone comes back to me able to make this.
Of course I would pay for this to be made.
Used to be a turner myself for many years, feel lost without a lathe!
There was a bloke taking over where UK Neil left off, not heard much since though ?
Hw77+7
Cheers, if anyone has a link or phone number for the guy? Please drop me a PM.
I can 3D print one for you in gold - but it'll be plastic.
If that's any good to you
Sounds like a big olive!... i dont have the brass or confidence to do this first time, but if you are down in paisley you are welcome to show me a thing or two on my old metric boxford cud.
Donald
I can order a short length of 32 mm brass bar and have it delivered to.you. Will send you a PM later with exact dimensions and if its something you can do on your lathe then I will take you up on your offer.
Can arrange beer coupons as restitution as well!
Cheers
Steve
I can do this for you but I need the exact dims
Just pay for the postage pm me
All the best martin
Hi A.G,
Your good work arrived today, BRILLIANT!
Thanks very much, I can now complete my wee mod with a professional finish!
Regards,
Steve
PS - I do not add much myself to this forum but it's seen me through some tough times. Kept my interest in during lengthy bouts of ill health when I could not go shooting. Sometimes forum life is more useful than just the practical stuff we love to discuss