Hi chaps, these seem to be a bit like hens teeth but here goes.
Bsa standard 1934/35. Cocking link needed. If it wasn't for the fact it is missing I would give you the length. Have been told it should be 209mm??
Have tried Protek, Knibbs etc. with no sucess, any suggestions or help gratefully recieved.
With thanks.
Cheers.
Geoff.
They sometimes turn up on E**y
Hi, can you give me a diameter of the bearing area of the screw that goes though the push button front arm, ie. the front pick up point for the missing arm (which I assuming latches into the cocking slot at'other end).
reason is the 1930's saw some detail changes etc.
ATB, ED
While you fine chaps are rummaging to find Geoff a cocking link, should you stumble across one for the early BSA break barrel (B series), please let me know.
Hello everybody, thank you for all your help, Ed I will let you know ASAP the rifle is 40 miles away at the moment, I will have to wait for my son to pick it up for me.
Cheers.
Geoff.
Hi Goeff, have one here which is 7.5 inches from centre of pivot hole to rearmost end of part which engages in the piston slot...ie this dimension is it's ''working'' length, front hole is 0.191" if any good P.M. me a destination and it's yours
ATB, ED
Hello ED Many thanks, PM on way. Sorry for any delay, internet intermittant.
Kind regards.
Geoff.