I have PM'd Fozzy an apology. I hope he re posts his suggestion.
The pins are common to the 35, 80, 77 and 97 if that helps --- BTW, someone is breaking a 35 in the sales section. :-
http://www.airgunbbs.com/showthread....91#post7256391
The safety catch return Spring can be replaced by the spring out of a biro cut to length.
All the best Mick
If it's the 2 pins that hold the trigger unit into the back block then you can do as I have in the past. Use a cut down drill bit shank the same diameter as the holes. One end is already rounded slightly so just leaves the cut end to do. As for the safety return spring, a biro spring cut down to size will solve this problem. They are both easy and cheap methods.
Hope this helps.
Fozzy
Why not just buy the factory parts from Chambers?
As always, I've now found these parts whilst looking for some thing else. Now I need to remember what it was I was were looking...doh!.....
Thanks guy's for all of the suggestions, even to one who mentioned buying them from Chambers He evidently doesn't know how short my arms are