-
It's been a while since I had any s200 barrels ,
But pretty sure there was some labelling to indicate cz origin.
Done a few for tx now although the 15 mm dia gives less of a shoulder than the 16 would,
Concentricity has been pretty good too on most .
They seem tightish in the bore so might need a polish.
As a finished s200 barrel it would need post to rod or collect .
I asked them To chop a 1/2" off the breech so it didn't fit s200 any more
Got no evidence whatsoever and again can't remember why but had strong ideas that these go onto some isp guns
Lately been using v shArp hss to machine to avoid galling more visible under magnification
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules