you have pm
Just started reloading for my ne 223 and after a large quantity of good quality once fired brass, anyone know if there is any places that sell it.
I found this place https://www.armymad.co.uk/category/Bullet+Cases I had some 308 brass off him once that was really good, but the 223 stuff he sells is all mixed head stamps, would prefer it all the same.
Thanks
Dave
It’s sometimes best to keep your mouth shut and appear stupid rather than open your mouth and dispel all doubt…
you have pm
email...... stephenbarrow@ntlworld.com
Try Myles at MBR Sporting.
You may be able to pick up GGG brass at the NSC. I keep getting given the stuff that rapidly gets re-cycled into AR ammunition.
GGG brass is actually fairly good and often re-loaded, its not Lapua but with care its fine and quite tough stuff.
It is very easy to tell if it has been twice fired as its primers are ring crimped and the primers have a red laquer seal....so you will have to remove the crimp as well.
I'm a maggot in another life you know
Removing the crimp is a bit of a PITA but not so much if you have a drill and the correct tool which will cost about seven quid, the good news is you only have to do it once and the brass is worth it because its pretty good quality and annealed well. One thing to be aware of if you do go the GGG / surplus route is the brass is generally thicker walled than commercial brass so you will get more pressure more quickly, general advice is you should lower max load by 1 grain.
Other than that just keep an eye out on the for sales section on here and on the stalking directory as once fired comes up quite regularly which is the beauty of 0.223!
Thanks for looking
Take a look at egun.de.
All done by bank transfer but excellent service and not experienced any problems.
I recently bought 2000 once fired RWS .22 Hornet cases for re-sizing to .17 Hornet.
All came out like new when cleaned, and re-sized and fire formed without issue.
A few vendors sell mixed bags of 500 or 1000 once fired brass for around 100 Euros. You should find a few hundred of the same make in a batch that size.
I'm a maggot in another life you know
"An infinite number of monkeys banging away at type writers for an infinite period of time will eventually reproduce Hamlet" Thanks to discussion forums we now know this to be untrue.
Indeed, I may pick out the best ones and turn them into disposable creedmoor cases for when catching brass is less than practical!
The fed brass is going strong now it's been annealed so going to turn some more .243 into 6.5 CM, keep me busy until the 25-45 shows up
Thanks for looking