For a quick, cheap fix use a short length of drill bit (the round end obviously!) and a smear of epoxy to hold it in place...
A friend has a TX200 with a problematic Cocking Arm in that one of the rivets holding the Arm to the Pivot Block has failed and needs replacing. Is this a standard engineering part that can be brought separately or is it a new Cocking Arm as a complete entity ?
Also, has this happened to anyone else, and if so, how did you overcome the problem ?
Thanks, Vic Thompson.
For a quick, cheap fix use a short length of drill bit (the round end obviously!) and a smear of epoxy to hold it in place...
thanks for the replies folks, I'll forward them to the "lucky" owner of the rifle.
Vic Thompson.