My 0.177 HW99 has had the usual fettling including a Delrin top hat, spring guide and a PTFE piston sleeve. It currently has the standard HW mainspring without preload washers, and shoots JSB 8.5 gn. at 11.25 Ft.Lbs.
I would like to trade some power for a smoother firing cycle, thinking that an alternative, softer mainspring would be a better solution than cutting a coil or so off the existing mainspring.
Is fitting a softer mainspring the best approach, and if so could someone suggest an alternative mainspring?
Thanks and Best Regards,
Bill.
The .177 will run much smoother at 10.5. Lose half a coil and try again, repeat if necessary.
Better to admit you walked through the wrong door than spend your life in the wrong room
As the man says above, just shortening the existing spring slightly may well have the desired effect.
I have a WonkyDonky kit in one of my 99s and it's lovely. You could approach him and see if he has a spring. I could well be tempted to ask him for a .22 spring, sacrificing power for the even milder cycle that you are after, although some would say that it may drop the power too low. Worth a try in my opinion and you could add a little preload if the output was too low.
If you have the spring out of the gun at present, you could check its measurements against some of those stated on the Mainspring Data Thread in the Useful Tips section.
If choosing a new spring, don't forget you'll need to make sure that the guide (and top hat if desired) fit properly.
THE BOINGER BASH AT QUIGLEY HOLLOW. MAKING GREAT MEMORIES SINCE 15th JUNE, 2013.
NEXT EVENT :- May 17/18, 2025.........BOING!!
Thanks all for the advice. A thought: would collapsing a coil have the smoothing effect on shooting characteristics I'm after?
It seems that this would be the equivalent of shortening the spring and adding some preload washers, and wouldn't involve having to refinish the spring end. If it wasn't beneficial I could then remove the collapsed coil and refinish the end to achieve the shortened spring situation.
Best Regards,
Bill.
I run mine with a longer, softer spring. Nicer, softer firing cycle, easier cocking, and less piston bounce.. power is actually unchanged at just over 11 (in .177)
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
I remember talking to Shauny about this and he finds a Titan meteor spring (cant remember the number), works well in these. Probably need a piston sleeve as likely be of smaller diameter.
Ah yes I know that spring
Bill,
I fitted a 0.22" Wonky Donky service kit into my 0.177" HW99S, and it made ca. 10.0 ft.lb, with no compression washers fitted.
Lovely to shoot, and much easier to cock that when the rifle is at ca. 11 ft.lb.
Compare the trajectories of 10 ft.lb, and 11.5 ft.lb in Chairgun, and you see you are losing virtually no trajectory with 10 ft.lb
Have fun
Best regards
Russ
Shortening a spring increases stiffness so not the ideal way to go. If Konceptus starts trading again their springs are very nice - softer than standard. My Konceptus kitted 99 is excellent.
For a meteor spring use an early mark of meteor and original equipment...
Titan meteor spring is no. 5. I have used these in some guns but wouldn't say they were particularly soft. The spring in my HW50 is an old one out of my 22 95. Produces 11 in 22. TX mk3 springs are quite weedy so may be worth a look to see if they would fit.
Plinkerer and Tinkerer