Aren't they an unusual size, m7?
I have an old 77 in a target stock and I assume the stock screw(screw in front of trigger) is not quite right as when I unscrew it, it takes the retaining nut with it.
I then have to use pliers and a cloth wrapped around the retaining nut and an Allen key to undo these, then reattach the nut to the action.
So what do s the thread of this screw?
Regards,
Matt
Aren't they an unusual size, m7?
www.shebbearshooters.co.uk. Ask for Rich and try the coffee
The thread into the trigger block is M7, the thread into the Anti Beartrap lug is M6.
Ok thanks guys.
Matt
Perhaps your screw is just too long and bottoms in the lug when tightened then brings the lug with it on removal.
I think it is a finer pitch than standard 7mm .