11.2 diameter.gives you a bit of waddle room.4mm centre bore.to a depth of at least 6mm.pins 2mm diameter. 8mm centre to centre
problem is push pin disc blind holes can differ slightly .
kevG
Guys, would anyone have the dimensions for the two-pin tool for removing the screw in a Mk2 reg?
I need pin diameter, pitch, clearance hole diameter and outside diameter. Any help greatly appreciated.
Jonathan.
11.2 diameter.gives you a bit of waddle room.4mm centre bore.to a depth of at least 6mm.pins 2mm diameter. 8mm centre to centre
problem is push pin disc blind holes can differ slightly .
kevG
Chap sells the tool on the bay of e, mk2 or MFR.
On the subject of rapid regs does anyone know the size of the circlip (and ideally where to get them) on a MK1 reg?
I just received a rifle and someone has replaced the circlip with an o ring and a lot of superglue!
they are not mk1 regs.just the early version that you got on the early mk2..got some some were will have a look.
kevG
if it's on a mk1 it may have had action reported to take reg.
kevG