Results 1 to 7 of 7

Thread: Loctite for push on moderator (HW90k)?

  1. #1
    Join Date
    May 2019
    Location
    London
    Posts
    13

    Loctite for push on moderator (HW90k)?

    Something previously discussed in older threads but mainly for scope screws etc...

    Wondering what would be best to hold my push on moderator on end of barrel HW90K)?

    I have 222 but wondering if will be strong enough. Will also have grub screw.

    Many thanks!

  2. #2
    Join Date
    May 2008
    Location
    Quigley Hollow, Nuneaton
    Posts
    17,125
    Hi Bez

    With 222 being a low strength adhesive, I'd be looking at something with higher strength like Loctite 271 or above.

    I now use a really high strength adhesive for weights and silencers which I got from my local Motor factors --- I'll find it's name out for you later.



    All the best Mick

  3. #3
    Join Date
    May 2019
    Location
    London
    Posts
    13
    Thanks Mick appreciated.

    I'll hold tight, tempted to buy 638 to be safe.

    Looking forward to the name of your stuff.

  4. #4
    Join Date
    Jun 2012
    Location
    Scunthorpe
    Posts
    290
    Loctite 638 is extremely quick grab / set time, hardly time to adjust if you needed to
    . . . Please INDICATE when overtaking cyclists !!

  5. #5
    Join Date
    May 2019
    Location
    London
    Posts
    13
    Quote Originally Posted by GrahamHenderson View Post
    Loctite 638 is extremely quick grab / set time, hardly time to adjust if you needed to
    Cheers good info. Another one you'd suggest? Want it rock solid, if need to ever remove in future I'd get the heat gun on it.

    Would only need a few seconds to slide on and align the hole for grub screw (with mark in barrel where previous grub screw was fixed).

  6. #6
    Join Date
    May 2008
    Location
    Quigley Hollow, Nuneaton
    Posts
    17,125
    Quote Originally Posted by Bez_01 View Post
    Thanks Mick appreciated.

    I'll hold tight, tempted to buy 638 to be safe.

    Looking forward to the name of your stuff.
    Here you go, Bez. :-

    image.jpg

    I use this for gluing barrels into breeches and for fitting barrel weights and shrouds etc.



    All the best Mick

  7. #7
    Join Date
    May 2019
    Location
    London
    Posts
    13
    I'll look into that! Thanks Mick

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •