Reply With QuoteMy friend used to use something similar to these when he worked on Sheridan pump up rifles.... don't know if these would work for you???
https://www.toolstation.com/box-span...gaAmnSEALw_wcB
Registered User
I’ve got a Sheridan K series co2 paint ball “rifle”, and the valve is leaking. I think I need a Sheridan/Benjamin valve tool to remove it - does anyone know of anyone that supplies/makes these in the uk?
Regards
Springfieldm6
Registered User
My friend used to use something similar to these when he worked on Sheridan pump up rifles.... don't know if these would work for you???
https://www.toolstation.com/box-span...gaAmnSEALw_wcB
Registered User
This is the one I use for Benjamins, it has a square end to fit internally in the nut, and an internal thread on the yellow arrow side that screws on the valve to pull it out. Got this from the U.S. but I think --ped-- may make them.
Baz
[IMG][/IMG]
BE AN INDEPENDENT THINKER, DON'T FOLLOW THE CROWD
Registered User
Hi, I do not know if the valve is the same as 'Streak's'? try TR Robb.Originally Posted by springfieldm6
Last edited by cringe; 21-12-2019 at 08:46 AM.
Registered User
Excellent, thanks for all of your help - looks like the tool I need above. Will try t.r.robb.
Registered User
i make them now and again inc a valve extractor thread and wing nut
https://imgur.com/MZXanCW
Last edited by --ped--; 19-12-2019 at 10:47 AM.
Registered User
And very good they are too.
Registered User
cheers Stu
Registered User
The rifle looks familiar Ped!
Registered User
that's the problematic one i think Allan which was extremely tight still once i made the holding fixtures it came undone
Posting Permissions