Have u checked the power settings mate
Run my mk 4 over my combro yesterday and it’s putting out about 9.8,would a duff battery cause this??
Have u checked the power settings mate
That's unusual.
Electronic Daystates are normally over.
They are the HW80 of PCP's.
Master Debater
more likely crap/gunge on the hammer
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
Charge it for 16 hours and see what the voltage is once charged...it should also say ip voltage good when u plug it in, if it says anywhere over 7v when charged and it's still low on power then I'd suggest maybe a service...or a seal is needed.
Just been doing a little research and battery can effect the power as does the 0 ring on the pellet probe.
I charge mine religiously once a month whether I've used it or not....start with a good charge n see how u go
Keep us posted
It's been mentioned, but worth reiterating as it's very common - swap out the O ring on the pellet probe.
Making a mockery of growing old gracefully since I retired