Reply With Quotepossibly try bedding it .
some videos here https://www.youtube.com/results?sear...edding+a+rifle
Registered User
As above. A friends gun is rocking in the stock. Looks like too much has been taken off the wood at the side of the action. Is there any cure to this?
A Wise Man Can Act A Fool, A Fool Can Not Act Wise
Guest
possibly try bedding it .
some videos here https://www.youtube.com/results?sear...edding+a+rifle
Cooee! Chase me you naughty boys!
Chopped up inner tubes.
Master Debater
Registered User
is it a HW100
1 Rapid+sentinal n/v, 1 HW100+ Mamba lite
Registered User
You/he have several options,
1/. it could be that a high spot has been left & actually a bit more needs removing to stop the action rocking like a seesaw.
2/. it could be that the mounting bolt is bottoming out before it fully tightens so measure the depth, it might just need either a washer or a shorter bolt.
3/. Shim the fit with thin rubber sheet, as above a sliced open inner tube can be perfect.
4/. Properly "bed the action" with epoxy, cavedweller1959 on youtube gives good clear details, but remember several coats of release agent
Registered User
It is actually! Why do you say this?.Originally Posted by Bladerunner too
Just to clarify it rocks side to side. Not front to back
A Wise Man Can Act A Fool, A Fool Can Not Act Wise
Guest
http://www.airgunbbs.com/showthread....g-in-the-stock!
Registered User
i was going to say front to back , side to side is weird,
1 Rapid+sentinal n/v, 1 HW100+ Mamba lite
Posting Permissions