-
Wolverine leaking.
My wolverine is leaking where gauge assembly joints to breech. Small dowty washer. Anyone know which size I need? Thanks Keith
-
Could be 8mm? Can you remove it to measure? I had a leak in the same area on a Merlyn and it was 8mm. My notes from the time are:
'Leak found at the pressure gauge brass adaptor to the cylinder. Seal is 8mm Dowty. Bought from (id 8mm, od 14mm), fitted and hopefully leak cured. Take care if doing it again as the brass adaptor screws into a ‘loose’ part in the cylinder, so keep cylinder horizontal, gauge up, when removing gauge.' I have vague recollections that the seal was a 'German' size.
Now I cannot vouch for the accuracy of the above for your rifle but I remember being surprised that the Dowty was not what we might call a standard size.
Cheers, Phil
-
Got it mate. Just the same dowty that fits the air hose etc.
-
1/8" BSP then!
-
It's quite common on daystates , And the filler asembley dowty washers, You could try and nip it a little which I done on my air wolf, It stopped the leak, I not long changed the ones on my air ranger filler , Both dowty washers, Bought mine from a gun shop selling from the auction site,
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules