-
Hammerli master/single spares
Hi, has anyone got or know where i can get a pop-up loading post/tap for a Hammerli master/single pistol please.
Grateful for any help,
Atb,
Steve.
-
I have a D452 Single 'lange'
It's the older model without the over-travel stop but I doubt they changed the loading port.
I can measure that if you think it's the same.
-
Hi Obsidian69, mine as the same model number D 452, so if you dont mind yes please , ive got another member who as one that has said i could get the measurements from be good to compare the two.
Many thanks,
Steve.
-
You may need a diagram but let's start with raw data:
- overall length: 1.751"
- Diameter: 0.354 - 0.355"
- Length of flat section: 0.858 - 0.859"
- Width of 'pop-up' groove: approx. 0.11 - 0.12"
- Diameter @ groove (not incl. flat section): 0.318" - 0.319"
- Width @ groove (opposite flat section): 0.276 - 0.277"
- Width (opposite flat section): 0.293 - 0.294"
Sorry for using Imperial but I couldn't be bothered going out in the cold to get
my metric Vernier.
-
The issue you will have is getting the slot/detent in EXACTLY the right place so it doesn't shave lead off the pellets as they jump from the loading port to the breech.
PS. I realised I didn't give you centre of pellet hole to top so I'll do that sometime but I'm out on the razz tonight.
-
Photos sent to your email.
Last edited by Obsidian69; 19-01-2023 at 05:45 PM.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules