Its fairly common with these I believe...my AP604 used to leave ragged holes fairly regularly.
Hi.
My 6004 is shooting ragged holes at 10 metres...this is not normal I know.
Someone said its my seals that need replacing??
If so, is there an easy to follow video to follow so that I can do it myself.
Also where do I get the seals. I've done it on my hw100ks and aeron brno b96.
Cheers
This is the crisis I knew had to come, Distroying the balance Id kept.
Turning around to the next set of lives, Wondering what will come next .
Its fairly common with these I believe...my AP604 used to leave ragged holes fairly regularly.
Last edited by harvey_s; 25-09-2023 at 09:58 PM.
You might get a few extra FPS especially when the seal is new, but these aren't powerful pistols and velocities in the 330-350 region are pretty common in my experience.
Personally I think the pellets at this velocity can begin to tumble at 10m - but it isn't a huge problem and they still fly to the point of aim it's just you end up with a ragged hole.
Maybe try a introducing a drop or two of pellgun oil at the breather hole on top of the cylinder as you start to open the top cover...then open it up fully and let the oil get sucked in.
You don't want a lot - just enough to coat the wiper and help the seals a little.
Hope that helps...
Thanks Harvey..I'll give it a go.
Cheers
This is the crisis I knew had to come, Distroying the balance Id kept.
Turning around to the next set of lives, Wondering what will come next .