mk3 webley trigger assembly?

[Scorpio54]

Can anyone please help? I have stripped the trigger assembly on a mk3 rifle, on re assembly there is no way I can work it out!! it sure looks simple enough as there are only 3 main components, the trigger, the spring that fits in the middle and then the front sear piston latch. the spring fits in the middle of the two, problem is I cannot get any space between the trigger and the sear to locate the spring? I have tried assembling each part 1st to locate the spring, but cannot compress the spring enough to locate the 2nd part (applies whichever way I try it).
i have tried youtube and the internet but cannot find a link showing how its done.
Annoying part is always on disassembly it comes apart sooooo easily.
Any guidance gratefully appreciated.

[Re01312]

Did you take a picture before disaessembly?

[Scorpio54]

Now sorted ! thanks to a bit of advice from Guy (GGGR) sod of a job, wont be stripping that part again.....

[MDriskill]

From Dennis Hiller's Collector's Guide to Air Rifles. This re-assembly method worked perfectly for me (and I am NOT a talented mechanic).

[Benelli B76]

And the early model is completely different.

Baz

[MDriskill]

And the early model is completely different.

Baz

Understood, but the OP's original question clearly describes the later, much more common trigger as in the drawing.

[Benelli B76]

Understood, but the OP's original question clearly describes the later, much more common trigger as in the drawing.

Was also understood by me, well aware of the situation. I just mentioned it out of interest as some people do not know the earliest Webley had a Diana type trigger unit. I have one for sale at the moment after converting with different piston and trigger.

Baz