Progress....
Made tweaks to a fubar reg I had (it leaks clean thru due to some muppet drilling holes in it, but it doesn't leak out the vent hole). This enabled me to mount the valve return spring on something.
Then fixed the o-rings inside the S200 cylinder that had gone rock hard, and screwed it all together. I do have the cover for the reg/reduced part of the action to tidy it up, but I need to machine a couple of mill off it first.
Filled it up and all good. it cocks and fires and goes bang (rather loudly). Just need to make the barrel now, which uses an internal o-ring, so a lot trickier than a regular rapid arrangement. Not sure I have an internal grooving tool small enough...
Oh, and a stock, almost forgot that...
Last edited by Shed tuner; 17-04-2024 at 08:35 PM.
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.