.
Think you'll find it virtually impossible to get it to 5 ft.lbs+
would dearly love to know how myself without adding a 4 ft long barrel
ATB
Pete
.
p.s yes,put a steel BB in 1st to stop distortion .
.
Think you'll find it virtually impossible to get it to 5 ft.lbs+
would dearly love to know how myself without adding a 4 ft long barrel
ATB
Pete
.
p.s yes,put a steel BB in 1st to stop distortion .
.
Drozd barrels screw straght in unless it's an early model Mak (pre 1999)
(NEVER unscrew without the mag in place)
Few good links if they're still there >
http://www.geocities.com/airecolabora/baikal.htm
http://www.makarov.com/
http://www.makarov.com/co2/instructions.html
grips>
http://www.makarov.com/graphics/co2/CO2_SE2.jpg
ATB
Pete
.
Last edited by PALADIN; 20-05-2008 at 10:49 PM.
http://www.airgunbbs.com/forums/showthread.php?t=21854
http://www.airgunbbs.com/forums/showthread.php?t=25621
http://www.airgunbbs.com/forums/showthread.php?t=23155
http://www.airgunbbs.com/forums/showthread.php?t=30315
piccys of cut-off base >
http://www.airgunbbs.com/forums/show...86#post1439986
few more to dwell on
Pete
Last edited by PALADIN; 21-05-2008 at 02:55 PM.
This is what I need some Excellent advice here guys
As soon as I get one how about setting up a mak owners club?
I personally only use the lead bbs and as long as you don't try and get too many shots out of it you should be o.k,as far as leaving the Co2 capsule in the mag,I don't, after a good plinking session I spray the seals in the mag with Silicon to keep them in good condition.