Although if I had to hazard a guess, I'd say the 335 sight looks more like one off a Norica.
Dodgy Diana User
Although if I had to hazard a guess, I'd say the 335 sight looks more like one off a Norica.
Registered User
I will look further on that suggestion Geezer.Originally Posted by Geezer
Do you have a reference model or image link?
Registered User
Urgent information sought
I am having the dovetail defects welded.
When the completed rifle is blued, am not wanting the repairs to show up like the proverbial dogs .
Does anyone know the metal composition of the Anschutz receiver/air cylinder so the nearest correct wire can be used?
I have sent Anschutz an email but at this point there hasn't been a response from them.
Last edited by slow_runner; 14-07-2016 at 07:38 AM.
Registered User
What measurement do you require?
Registered User
I just reread my post; that is a good question Mick
The centre height of the original front sight. Measured from the top or bottom of the barrel outer would do the trick.
Cheers.
may also be employed in conjunction with a drawn reciprocation dingle arm, to reduce sinusoidal repleneration
An HW foresight can usually be adapted to a dovetail, either by machining it to make it wider or by shimming it with brass L section strip to narrow it in. The rear-sight on an Anschutz 335 is a lovely piece of work.
Registered User
Probably not so useful for your predicament, but my Mk1 335 has a Williams style rearsight, with a target foresight containing a post. I could take measurements, but do not have it to hand tonight. Could possibly do it tomorrow?
Posting Permissions
Reply With Quote