i promise to start on my 52 project this week ....i've been hoarding model servo linkages
i promise to start on my 52 project this week ....i've been hoarding model servo linkages
them there springer's are soooooo addictive
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
https://imgur.com/a/qLbDdzR
Bit of an unusual approach to attaching a comb to the pup but it works remarkably well , will replace with a new one at some stage
What isn't obvious is how I managed to keep it in place.
A small magnet is inlet into underside of comb so even if turned upside down the comb stays put
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
https://imgur.com/a/0VGCEbF
After 3 coats of oil
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/