Rapid stocks-which ones fit which actions?

[Daveo]

Isn't the mk1 trigger blade a diffrent length to a mk2 ?
I thought it needed some kind of mod to make it fit ?

[Rapidnick]

Isn't the mk1 trigger blade a diffrent length to a mk2 ?
I thought it needed some kind of mod to make it fit ?

I have actually run a Mk 1 action in a Mk 2 stock. but it was some while ago. What was the problem-was the mk 1's trigger too long or too short?

[johnfaulkner]

if i remember right from my previous mk1, i had the mk2 stock fitted and i think the trigger blade was too short. easy sorted with a shoe

may be wrong though

john

[Rapidnick]

if i remember right from my previous mk1, i had the mk2 stock fitted and i think the trigger blade was too short. easy sorted with a shoe

may be wrong though

john

I think you are right John. I didn't remember it as a problem because I always fitted a trigger shoe to a mk 1.

[wall90]

i have a mk2 stock on my mk1 regulated action,with trigger shoe fitted as low down on th blade as possible.it all works fine.even the safety catch is ok.

[Sam@CS]

Simple, anything will fit anything else if youre determined enough and have the right tools.

Regards,

FAC Mk1/2/MFR hybrid owner.

[Rapidnick]

Simple, anything will fit anything else if youre determined enough and have the right tools.

Regards,

FAC Mk1/2/MFR hybrid owner.

Well done Sam!!! I should've specified in the thread starter 'without major cutting being needed'.