Yes. Had to pack out the rear. Not alot. Bit it was maxed out and was still 4inch low..
Hawke mounts. New.,!
Atholn argos scope. New.
Zero moa mount on rifle..
Registered User
Yes. Had to pack out the rear. Not alot. Bit it was maxed out and was still 4inch low..
Hawke mounts. New.,!
Atholn argos scope. New.
Zero moa mount on rifle..
beretta dt10 ,kofs 20b, ESCORT 12g semi-CAMO, 1022 ruger Volquartsen. Cz512 tactical Barton custom. 223 howa 1500 GRS stock
Registered User
Well I'm using virtually the same as you component wise....imi brass, cci primers, n133
SBK = 24.5gn n133 and good for sub 1/2" MOA
53gn V Max = 25.5gn n133 good for sub 1/2" MOA (should be same for A Max)
all from a remmy 700 SPS tactical 1 in 9
hope that gives some help....please build up to these charges as they are quite near pressure threshold in my rifle...im also seating my bullets quite long (2.290") to be close to lands ...
Without curiosity, evolution would have been greatly flawed.....
Registered User
swap the mounts front to back the scope shouldn't be maxed out at .223 ranges, you are using the Howa rail? is it fully seated?Originally Posted by g60bv
You Cannot Reason People Out of Something They Were Not Reasoned Into
"Politicians like to panic, they need activity. It is their substitute for achievement" Sir Humphry Appleby
Registered User
Planning to do some load testing using N130 with 40 gr vmax and 53gr amax next week..
Posting Permissions
Reply With Quote