Original Model 35 re assembly

[junglie]

From memory, I made two short pins to hold the two 'tubes' together and held the balls in place with grease.
This assembly was put on the end of the spring guide and pushed into the main cylinder using a spring compressor until the ends of the short pins were visible through the holes in the main cylinder.
Then the proper retaining pins were pushed into the holes which pushed out the short pins out the opposite side,

Hope this helps,

Best regards
Bill.

The simple ideas are always the best , will be using that one next time i strip my 35, thanks.

[Papa g]

The simple ideas are always the best , will be using that one next time i strip my 35, thanks.

Yep same here, I need to strip it to fit a new spring this now gives me a good excuse to give the short pins method a go😊
Regards Graham