Just one question

[greenwayjames]

Yep, there are loads of them.
Did you know that J Bowkett designed the Zebra?
If you look closely enough you can see the design of his sticker in the stripes.
He will blueprint one for you too if you ask him nicely.

Reading your reply there are a lot more than just zebras wandering around sheffield. Care in the community has a lot to answer for

[Arthur John Smithsplease]

Why do AA insist on keeping that knitting needle of a barrel on their S400/410 series?

I know they sell well, but they'd sell even better with a thicker barrel, screw cut to receive a silencer of the owner's choice.

[Two200's]

Reading your reply there are a lot more than just zebras wandering around sheffield. Care in the community has a lot to answer for

Sometimes jokes are funnier when you have to explain them.
This time, sadly not.
Also, it was quoting you, not replying to you, please be more discerning.
Just so you get it this time - i am am replying to you in this post.

You see, you could not resist adding something could you? A bit of jovial banter and some funny stuff and you jump in and as soon as you do - your posts are directed at the people posting, not the manufacturers. Again - lost the plot of the thread.

I don't see what you put on the table here, ok, so you have a working knowledge of a few manufacturers histories, but you never help people out - you just bandy your knowledge and your opinion about.

Posters have publicly asked you not to comment on their threads.

Its so dreary to deal with you like this but publicly i want it to be known, that i too, don't want you posting in reply to my posts or threads.

I take my leave of you.

[greenwayjames]

Its so dreary to deal with you like this but publicly i want it to be known, that i too, don't want you posting in reply to my posts or threads.

I take my leave of you.

Ditto

[where's it gone]

BSA......if research and development cost so much, why did you bring out the R10 mk2 so soon after the mk1 ? and slightly off topic, what was the reason for Airgun World to revert back to the A4 size mag ? oh yes, cost ?

[Rickenbacker]

Scope manufacturers - Why don't you paint little level markings on the sides of scope tubes? So that we could line up the scope in a minute, instead of half an hour using at least two bubbles and a plumb line.

Is it because you can't possibly put the effing reticles in straight?

[MrGrumpy]

Scope manufacturers - Why don't you paint little level markings on the sides of scope tubes? So that we could line up the scope in a minute, instead of half an hour using at least two bubbles and a plumb line.

Is it because you can't possibly put the effing reticles in straight?

please please please make this happen

[keithy]

All airgun manufacturers. For goodness sake stop fitting anti tamper devices to our guns, if we turn them up its OUR FAULT!!!!!

[Terry D]

... what was the reason for Airgun World to revert back to the A4 size mag ? oh yes, cost ?

No. Enough readers asked for it. We had about five times as many complaints as we had positive comments when we went oversize A4. We thought it was a good move, those who really matter thought it wasn't.

Yes, there are slight savings, but resizing every template negates around two years' worth of anything saved, plus it's a pain in the arse to do, but the readers wanted it, so they got it. It really is that simple.

[jim caffery]

All makes, full power semi auto please.

[where's it gone]

All makes, full power semi auto please.

Took 3 years but, as far as I know, Steyr obliged. Can we have more to follow, please.