Having stripped the relevant block out, I find a 2BA screw fits. Why a 2BA would not fit with the block assembled on the rifle in the first place I do not know. if this thread is really 2BA then it could explain the untidy appearance of the guard screw fitted. Maybe this screw was forced into a 2BA thread???
Whatever ... onwards.
I continued my look at the rifle by stripping it. Not too bad really but the spring guide was a pretty loose fit in the spring and the large circular end broken off. New guide is being made. Small O ring breech washer was somewhat damaged BS 010 seems to fit OK in the recess but I do not have the larger O ring. I think it is OK though. Mainspring seems fine... must measure it, as it the piston seal. I will also add a piston sleeve.
So next ... trigger reassembly. Why do I expect coffee to be in demand?

At least it is raining here so I would not be outside anyway.
Cheers, Phil