A bike tire inner tube at the bottom then do the bolt tight.
A bike tire inner tube at the bottom then do the bolt tight.
Master Debater
Hi I used green felt stuck to the sides and near the back theres a screw hole they use for a Mk1 block trigger guard screw a bolt in then cut off so it sticks out about 3/4mm this grips into the stock and pevents movement.
mine also wiggles...completely unacceptable for a rifle of this price!!! As are quite a few other things on it!
www.delgi.com
www.olympicguns.co.za
Steyr LG110 FT
Steyr LG110 HP .20cal
Steyr LG20 FT
AA S400 Ginb FT
HW100 FAC Ginb FT
FX Verminator,Gladiator, Ranchero
Logun Axsor
Logun S16Xs FAC
FWB300S
AA Venom ProSport Ginb FT
AA Venom TX200HC CS1000
Steyr LP50 and LP10
SAM K15
Theoben Evo .177
Theoben Crusader .20
BSA Lightning XL Tactical .177
Winchester Mod52 .22LR silhouette
Hammerli 152 Electronic .22 free pistol, others...
If you have this problem first check that the bolt is not too long. I have found that stocks vary in thickness around the bolt fixing. Either that or the countersunk hole on the outside of the stock is sometimes drilled too deep. Anyway, try using one or more extra washers until the action is really tight in the stock. Packing like inner tube rubber is fine as well but I would go the bolt route first.
'It may be that your sole purpose in life is to serve as a warning to others'.