Originally Posted by
Mr.Fixit-Norm
I meant to ask this as well the other day, do you make them a complete cylinder or do you have to leave the bit clear where the cocking slot is ?
Cheers,
Norm
complete, with the join on the opposite side to the cocking slot. a small gap at the join is fine - an over-lap is not.
The cocking shoe shoudl ride on the cocking slot, and not dig into the sleeve. If it does, smooth the cocking shoe, as it would be gouging into the spring too.. then fit a new sleeve 
Have you made that 15 g steel TH yet ? 
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
Reply With Quote