Quote Originally Posted by steptoe1966 View Post
I would say use a dremel with a diamond bur ball bit in it , just get the smallest you can and then just take your time , pratise on a scrap first to get the depth you like and then your away ,i did my daystate stock but can't put picture on here , the outline can be marked out and use a cutting bur or just a very fine straight bur cut the line and then just go deeper and then you can open it up once you have a track to follow run a wider bur along it to open the border up or leave it thin .
Just go slow and steady but when your hand gets tired stop or you will make mistakes
I've tried a dremel but found I just couldn't control the depth with any finesse. I suspect the grain of the wood plays a big part in this?