I use the little black plastic caps that cover the knots in the elastic which hold the scope covers together.
They are FREE
I use the little black plastic caps that cover the knots in the elastic which hold the scope covers together.
They are FREE
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
You could go for black grub screws, either slotted or hex head as you prefer. Not sure on size but could check mine later if it helps and give a supplier link.
I used black Milliput two part epoxy putty.
Put it in and smooth over the top.
It dries hard.
Arthur
I wish I was in the land of cotton.
I was going to suggest the endcap of a black ballpoint pen
Torn between the LSD cap, & some brass rod as a bit of bling on mine
Not done it myself yet, but when I do I’m going to try this stuff
https://www.amazon.co.uk/Sugru-Mould.../dp/B01BFE0KNQ
Thanks