Thanks Ian.
Is the mainspring retained by the round screw block located front of the trigger unit?
Am I able to safely remove the end cap without a big boing!
Using some logic(?); I am looking at it and it appears that I should be following this sequence:
Remove end cap.Is there any load on this cap?
Slide back the scope mount, carefully lift and remove.
Remove trigger unit.
Compress the mainspring, then unscrew the round block/retainer(?).
Originally Posted by I. J.
They are a pretty straight forward rifle to strip but I do recommend the use of a spring compressor.
Also the scope rail must be removed (one screw) for the end plug to be released.
ATB
Ian
Reply With Quote