At £60 to £70 each these are not cheap, but in the end are worth it.
Neil
At £60 to £70 each these are not cheap, but in the end are worth it.
Neil
Current airguns:- Steyr LG110: Steyr LP10: Air Arms HFT500: Weihrauch97 fully customised.
AA S410K:Cardew modified Mk1 HW80 4mmTP, barrel shortened no choke Venom Tyrolean stock Titan Accelerator spring, TbT top hat & guide :CZ 16"bbl .22LR Varmint:12bore MOB O/U: Webley 812 auto:.308 Surgeon/Border barrel by Dave Wylde now Valkyrie Rifles BASC/NRA
Not if they are properly bedded on pillars
And bedding three rifles is much cheaper than paying out for a torque driver (yes i'm cheap)
I think the J&P screws and spring are well worth the money.
And for the nay sayers, a rounded off cheap allen bolt is much easier to drill out then a slotted screw, and no special jig is needed
Neil.
hi,palace if you dont mind me asking how much did they cost with the
exchange rate +postage. i could do with 2 sets one for my cz17hmr and
22 varmint cz cheers.
bob
bob64
http://www.jnpgunsprings.com/ this is the link to J&P I dont know if with the fluctuations in the exchange rate the price would be the same I paid less than £20 for the lot @ $2 to the £ an alternative is Rimfire Technologies who have the wood screws as well, http://www.rimfiretechnologies.com/S...lts.asp?Cat=42
There is a good reason to use a torque wrench other than perceived accuracy improvement (my CZ 452 Varmint is pillar & skim bedded) & that is I'm 21 stone, with years of wrenching bits out of old cars, so it's not always that easy to judge a few inch lbs...
I am looking forward to the first to come up with a steel trigger guard to match my matt finished Varmint.
AA S410K:Cardew modified Mk1 HW80 4mmTP, barrel shortened no choke Venom Tyrolean stock Titan Accelerator spring, TbT top hat & guide :CZ 16"bbl .22LR Varmint:12bore MOB O/U: Webley 812 auto:.308 Surgeon/Border barrel by Dave Wylde now Valkyrie Rifles BASC/NRA
thank palace for the info mate like the one piece weaver mount as well cheers .
bob