.30 cal sabots

[CannonFodder]

Looking for the little plastic sabot not the full round

How about getting some 3D printed, would that work?

[loiner1965]

How about getting some 3D printed, would that work?

Possible
Waiting to go to range and do some more testing and see if consistent and accurate first .

[CannonFodder]

Any chance you could put a picture of a sabot up?

[loiner1965]

Any chance you could put a picture of a sabot up?

not the best pic but it shows you what they are...... .308 case and .223

[CannonFodder]

Yes, I get it, 3D printing is obviously a no go.

I found this: https://www.eabco.net/Accelerator-Ty...0_p_13645.html

I know it's out of stock at the moment, but you may be able to find some elsewhere.

Sabot ammunition fascinates me, hence the input.

[loiner1965]

Yes, I get it, 3D printing is obviously a no go.

I found this: https://www.eabco.net/Accelerator-Ty...0_p_13645.html

I know it's out of stock at the moment, but you may be able to find some elsewhere.

Sabot ammunition fascinates me, hence the input.

plenty of you tube videos about it but accuracy is an issue but fun factor is good......sent you a pm

[DedIdick]

are they biodegradable???

[DesG]

Yes, I get it, 3D printing is obviously a no go.

I found this: https://www.eabco.net/Accelerator-Ty...0_p_13645.html

I know it's out of stock at the moment, but you may be able to find some elsewhere.

Sabot ammunition fascinates me, hence the input.

Why not? I made a few for the 38 and they work fine. I haven’t trie for accuracy yet but will next week just for fun. Quite slow to print but left on overnight produces 40 or so at a time.

[CannonFodder]

Why not? I made a few for the 38 and they work fine. I haven’t trie for accuracy yet but will next week just for fun. Quite slow to print but left on overnight produces 40 or so at a time.

OK, interesting. I've got a couple of tubs of the old Sabot Airgun ammo, I remember they weren't very consistent accuracy wise.