PP700W pistol

[paul4be]

Is anyone doing a proper little custom carbine stock for these yet?? Got to be a bit of a market for a proper solution?

[forbs]

Is anyone doing a proper little custom carbine stock for these yet?? Got to be a bit of a market for a proper solution?

I'm doing one at the moment. It's taking a bit of thinking about bit is more then doable..

Iv had the longer barrel made and screw cut to take a silencer (pic further up) so will be rifle size once it's done

[Waisted]

As amateur of interest I have fixed the iron sighs of a HW 99 on my .177 700 , the front sight I resin bonded and the rear sight I am currently making a block for the 99 site to sit on. On a good note there should be plenty of 99 iron sights available.

[Tony.T]

As amateur of interest I have fixed the iron sighs of a HW 99 on my .177 700 , the front sight I resin bonded and the rear sight I am currently making a block for the 99 site to sit on. On a good note there should be plenty of 99 iron sights available.

There you go guys- told you it could be done

[gingernut]

This lack of iron sights must be costing a lot of sales.
One to me for a start!

[Tony.T]

This lack of iron sights must be costing a lot of sales.
One to me for a start!

I took my home made iron sights off, I realised that my old eyes could not cope with them any more.

I bought a reasonably priced low profile red dot sight and for me it unlocked the accuracy potential in the pistol, now I can reset knockdown targets with ease at 20yds. Never been able to do that with opens. I'm happy

[Waisted]

I was testing the pistol last night, from a 220bar fill I got 160 shots shooting jsb 8.4 at 395 ft/sec 2.9 ft/ lbs, I shot down to the yellow. Absolutely gob smacked with the shot count and more than enough power for paper punching at 10 meters, this pistol just gets better and better.