Hi
I need to read this article!
Did you need make new guides or did the spring fit the standard lgv guides?
Hi
I need to read this article!
Did you need make new guides or did the spring fit the standard lgv guides?
Job done...
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
What kind of reamer did you use, if you don't mind my asking?
Donald
I had read previously on this site that it was advantageous to open up the LGU underlever transfer port but I was not aware the same applied to the LGV. Could you cast further light on this and the reasons behind it?
I also understood that the LGV was designed to perform at about 11.2 ft/lbs from new. Is this not the case?
I would like to see the Tyler article. Where can this be viewed?
Last edited by Vernal; 20-09-2018 at 09:19 PM.