Activity Stream

Even the Foster fitting was replaced, with one of them "one fits it all" setups. Ie; built in valving and what not, and at this rate the tube at such...

How do we solve that shade tree? I reasoned as such that them slugs are swaged to beging with so.. expanding them ever so slightly more shouldn´t be...

Hm. On the Kral Puncher Breaker. This then a 25cal, as i don´t live in Britain. Put it on a diet, for good reasons IMO. Run way different...

Funny I met her today and she is about as Chinese as you can get. His Chinese father in law died as result of an escalator accident in China and...

Hi Danny, yes l should have bought more from David Swans auction as there was quite a few bargains, but like your self l was a bit short of cash at...

Good & valid point, but the air can flow somewhere, it can squeeze back past the piston. The thin leading edge 'scoops' the air away from the...

I agree with this, especially with leather washers after finding lots of damaged piston screws where the washer breaks down over time to a point...

A selection of cans, a tin of pellets and a nice accurate open sight rifle is my idea of fun :oldgrin:

Definately prefer to fun plink than serious cloverleaf. Once the scope is zero'd & a good pellet found simply enjoy trigger time.

There have been a few designs trying to get the air to the TP I wonder if they worked.

Looking forward two it, lots of bargains especially when they get to my stall :oldgrin:

I fully agree....great fit and finish...and gives the right vibe to any break barrel. :oldgrin: Dave turned my one round in under 2 weeks from order...

Fair enough, Brian. I put £400 on it just in case nobody wanted it. :oldgrin:

I can echo the above. Great workmanship and a nice guy to deal with. Mach 1.5

Until the pellet releases, the seal is just compressing air and not flowing. A cupped seal will need a longer stroke to compress the air to the...

My exact thoughts, how is the sail/spoon shape necessary when the seal is working inside the large "cup" of the cylinder? I'm thinking the cup...

Its not so much the buttons but the panel that the buttons sit in. There is not enough defined edge that my fingers can easily identify the clover...

I have one of Dave's mods on a 35 - tremendous looking piece that actually works as a moderator too.

Dunno but the FWB 300 and FWB 65 made reasonable power with their weak springs and car-type piston-ring systems. The answer is probably far more...

Was shooting windfall apples in the garden with my 22 mercury s and rws super h points the other day, very satifying��

As an aside, if Webley had continued with wood grips we wouldn't have had to put up with all those so easily chipped grip plates often damaged when...

so I'm going to be difficult... in all these examples.. spoons moving through liquids, sails moving through air, the liquid/gaseous medium can...

Really looking forward to this. I always leave with my wallet lighter and my gun bag heavier!

It's simply a known fact, sails have used the same principle (in reverse) for thousands of years. the cup shape will also cushion the impact due to...

To start in the first place

Yep, recently started shooting at my local club, all sorts of targets at different ranges to shoot at, much more fun.

hit a blank cartridge with a hammer followed by a visit to the doctors,reckon i was about 14,twas a near miss:oldeek:

blimey,that would have got the pellet spinning:D

I have a Webley Axsor and did a bit of digging about the FX connection and this is my take on it. The Webley Axsor is the original gun made by a...

Hi Danny, That will mean the final price will be well over £3,000 after commission and VAT are added. It’s obvious from the realised price that...

Aye, thats the one