Activity Stream

https://www.firearmsnews.com/editorial/suppressor-innovator-phil-doc-dater/524909 The recently late, great, Phil Dater, who I had the pleasure of...

Fairly new to the market. It will probably be chinese in manufacture. I prefer the Crosman copperhead myself, the stock is nicer. Problem with...

26 x 86 IITC ? losing 10mm is a good place to be. HW99 that everyone likes at 11 fp is 72mm stroke IIRC. So the sweet spot for a sub 12 26mm bore...

Jeepers Neil ... very few things in life I have managed in two minutes ... or even four for the complete job :oldeek: Seriously though, this could...

No they folded feb 82. After that it was air arms. Some residual stock was sold off but one of the first improvements were the open sights.

Photos requested - and sent out - to six folk now yet only one has had the decency to get back to me either way. Very disappointing and so not what I...

Hi again Phill, it has been about ten years since I packed in making bits and pieces, but back then I was quite happy making £30 an hour in my...

Same here, I think it’s just something people use to moan about rather than it’s actual function and remember some probably haven't even used one 😂

What’s the bore and stroke of a 95 and is this a ballpark SS amount for a 95 tune

The 93 has a safety catch thing at the back, which means changing between 92 and 93s leaves a gap. I found that out the hard way. I don't know of...

:oldgrin:

I have one of this , and it's working https://www.youtube.com/watch?v=xf2DDmqOjg4&ab_channel=K.S.Airguns-AirgunPestControl

Nice to resurrect this interesting old thread... If you still have the book can you post a close up of the page with the Ball reservoir gun in the...

If anyone is bringing one to the bash, I would like to try and full length version

The last mainstream silencer I bought was an AM nelix, £120 and although good it smarted a wee bit and I had a look around and Ive been using a guy...

Can I just point out, that even at the first Bash there are queries around whether or not the bonfire is for the HE35s See Tony it's not a new...

Hi Neil ... good to hear from you. Interesting view but a thought came to me (ouch!) what would you cost your time at for an hour's expert lathe...

Hi Phill, The material costs are minimal and with CNC machinery, so is the time taken to manufacture the components. However the machinery to make...

Never really thought about it. I have two silencers made for me in the very late 1980's early 1990s. Only ones I ever bought were Galway units with...

Tony is the young Italian lad …….. pre ponytail :oldgrin:

Just had another go at it with no joy. The mainspring is in, so I'll try remove the cocking arm next, I think the tension from the detent is stopping...

I would like to see Weihrauch sort out the 57 loading port with a Stirling HR81 style bolt and a reliable rotary magazine.