Activity Stream

No going back now... even using my small 1000W angle grinder, with those thin 1mm cutting discs, it cut through 5/8" steel like butter... ...

What is the pattern supposed to be? Because it certainly looks very much like rust!

I was guessing you would say that JB..See you next month. Mach 1.5

hi chris sounds like gas starvation is the bulb being pierced properly ?if you have just changed the o rings they have no bearing on the velocity...

I asumed that it was on one of your many 77’s :oldwink::oldgrin:.

Im just tinkering and enjoying the ride, I’ll see what we got tomorrow :):)

Email explaining the issue. They will send a reply and address to post to. Don't expect a fast turnaround. Mach 1.

yeah, in many guns the loss of swept volume vs in the increase in preload does balance out fairly well (unless the spring is very stiff).. for...

HI thanks did you just email or call them? regards

Brilliant Thank you, and yes I’ve made a 15mm nose extension which will now give me 30mm of preload so I’m hoping to keep power at 11 as the loss...

The gas is flowing and the lead balls are coming out but not as high velocity as it normally does. Not sure if the gas seal at the front of the...

I've a BPK as a dedicated NV rat gun, mine has had no issues either. The grip creaked slightly when new then stopped doing it. The finish is fine and...

latch rod extension gives more spring room. more spring room means a smaller difference in force between the spring in it's cocked and uncocked...

Had a few repairs done. Both in German and USA..Yes you did read that right Germany. Sent via Viking Arms my last one. Mach 1.5

That’s got me thinking as to where I’ve put that now…

Thank you

Ah, I see what you mean. I quite like the thought of that so may have a look at my set up to obtain something g similar. I can see that aiding in...

Sales thread started

will try the trigger mods, but I'm actually OK with it now.. I think the reduced hammer spring load has made quite a difference to the weight.

small world, so do I :)

not wanting to dissapoint.... WTF !!!!! :oldeek::oldconfused::oldgrin:

Marvellous.:):cool:

Marvellous; very well done that man.:)

A pilgrammage to the Boinger Bash will happen👍👍

Remove the magazine and push on the valve to make sure you have gas flowing. If the gas flows then you probably have a blocked barrel or the magazine...

Now on the other hand, my Sirocco 2000 has a superb trigger but like you say, I've had numerous other rammers with bad triggers, its a shame because...

Very impressive set up. Not sure I can tell what the insulator blocks are made of. The manufacturers rigs are very complex and take all the vibration...