>>>>>>>>>>THE END<<<<<<<<<<...or is it...
>>>>>>>>>>THE END<<<<<<<<<<...or is it...
Evening Gents, nice thread on some oldclassics, i think all of these guns are good in ther way, i have Bsf70.22, anshutz 335.22. fwb sport mk2 .22 with macari upgrade. I enjoy all of them and would advise anyone to search any of them out. Whats the best one ! thats up to you all to decide for yourself, enjoy. atb
>>>>>>>>>>>FIN>>>>>>>>>>
Last edited by mallyally; 15-12-2008 at 10:07 PM. Reason: just had a crazy thought
It is a shame that they did not use the over-engineered system used by BSA. I guess it was their only break-barrel gun and thought that it would only be used for hunting i.e. only a couple thousands pellets a year, and not given the massive hammering that the FT brigades threw at it.
Trust you to degrade this wonderful thread by mentioning the Hungarian Fence Post.
Personally I think a lot of the so called 'problems' and weak spots mentioned above (HW35 catch sticking, FWB lock up etc.) can be avoided with the use of adequate good quality lubrication in correct amounts, care and maintenance and a bit of TLC.
Perhaps Im lucky but Ive never had a bad '35 cylinder or a 'Sport detent worn - but then again Im a stickler for lubing. I work on the old engineering principal that oil is cheaper than bearings (well, it used to be. )
ATB
Ian
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
Second you on that one I.J. I've don't think Sports really have any problems unless you are incredibly unlucky or abuse them.
I think also the triggers are very very good when compared to the real rubbish on other makes out there. They do the job and are consistent enough to get accurate results. They are just not a Record.
Never known or seen one to barrel droop or to bend up from premature release on cocking. I could definitely get a Theoben Serocco to do it but then any rifle with a heavy moderator on the end let fly under pressure might.
A tar and molly basic tune is all that needs to be done to quieten them and smooth them down. Maccari short spring and piston head drop in kit does it well enough.
Lastly, I have one fitted with a moderator and one without and there is not a lot of difference. Without one and no more than a ?x40 scope they are a marksman's dream sporting rifle; pure up into the aim point-ability.
I wouldn't imagine it would be too difficult for a decent machine shop to make a replacement bolt but then again a one off may be costly.
Rustybuzz, I've enjoyed reading about the early days of FT. My 80 was tuned for FT by your uncle early in the 80's. They were two of the major players back then and I remember talking to both of them at numerous shoots in the South East during those years.