Idiots guide to classic airgun strips (pt 1)

[ggggr]

I was hoping someone would put up the Webley sheets but they aint yet. The Osprey is more or less a sidelever Hawk mk3 and the trigger info above applies. Remove sights and the 2 stock screws, one at fore end of stock and one in front of trigger guard. Remove action and watch out for lump of metal in stock that helps locate rifle. Unscrew loading tap lever screw and remove spring and push out tap. You can change the seal if you want. Unscew trigger adjuster on top of endcap and remove circlips from trigger pins. Remove trigger pin and trigger and its spring. Remove other two pins and slide out safety, sear and sear spring.Take circlip off the ratchet and remove pin,ratchet and spacer (noting how it goes). Unscrew the pawl spring screw and remove spring and pawl. Knock out cocking arm pin and remove cocking arm. Knock out sidelever pin and remove sidelever and spring (noting how it goes) .Undo the allen screw in the end cap that secures the cylinder end pin. Push down on cylinder end plug and remove the cylinder pin. Release pressure and the end plug should come out, followed by mainspring and piston. (I had a problem with the endcap being really tight and it was a case of pointing it into some rap and waiting for iy to move and then knocking it out with a piece of wood) in this case ease it before you replace it. GO TO NEXT POST.