magicniner.....where are ya mate?
Can anyone recommend someone who can make the above pistol shoot full power 5-5.5Lb. Also approx ££££.
Thanks to all
Mick
HW100KT .177cal, FWB300s .177cal,Steve Pope lazaglide tuned resetable safety
HW97K .22cal, Brocock contour .177cal.
FAC Valmet lion .22RF Target Rifle.
magicniner.....where are ya mate?
PM sent
Airgun Repairs, Bespoke Airgun Smithing and Precision Engineering Services
http://www.magic9designltd.com
Magicniner PM sent
HW100KT .177cal, FWB300s .177cal,Steve Pope lazaglide tuned resetable safety
HW97K .22cal, Brocock contour .177cal.
FAC Valmet lion .22RF Target Rifle.
I got my Rohm shooting smoothly at 4.7ft/lb for the price of a few M4 washers.
If I took it above this, it started to fluctuate a bit, and muzzle flip started to creep in.
It's all logged here;
http://www.airgunbbs.com/showthread....Websites/page2
Hope this helps.
Bob.
Never take life seriously. Nobody gets out alive anyway.
It can be done with minimal fluctuation, I run one of mine at 5.2 ft/lbs for HFT Pistol and general knockovers, muzzle flip doesn't seem to be too much of a problem either
Just packing the spring to achieve increased power can cause problems though, increasing the reg delivery pressure and adding a helper spring which has no pre-load can result in a very smooth shooting, full power pistol that's still useable in double action with the 8 shot mags
ATB,
Nick
Airgun Repairs, Bespoke Airgun Smithing and Precision Engineering Services
http://www.magic9designltd.com
If you don't want to do the work yourself, you might try Robert Clevely at
www.checkmateguns.co.uk
Regards
Alan