Feinwerkbau have just sent me an email with the address of two German manufacturers who may have made this 601 mount, so I will contact them both and see if this produces a result.
If it does I will provide the info so anyone else can use it too.
Feinwerkbau have just sent me an email with the address of two German manufacturers who may have made this 601 mount, so I will contact them both and see if this produces a result.
If it does I will provide the info so anyone else can use it too.
Rossendale Target Shooting Club. Every Tuesday and Thursday evening 7 - 10pm.
Well done on tracking the information down, and to FWB.
I hope it all works out.
Sorry about the delay - it has taken some time to track down these two manufacturers and to get a reply from them.The two manufacturers concerned were Ernst Apel GmbH and Kilic Feintechnik GmbH.
Both responded with nice polite replies, but neither actually manufactured this elusive scope mount system to fit the Feinwerkbau 600 series rifles as shown here on this thread.
Now I need to start hunting again as these two leads provided by Feinwerkbau theselves as being the "most likely" to have produced this mount never actually made them.
The plot thickens!......the mount is obviously extremely well engineered by sombody - but who?
Rossendale Target Shooting Club. Every Tuesday and Thursday evening 7 - 10pm.