Air Force One Trophy Pistol

[richierich]

Hi just ordered one

What mods did you do to the trigger?

Thanks Dean

http://ukchineseairgunforum.myfreefo...6-0-asc-70.php for the trigger mod, it sets it back so it gives a shorter pull. It also allows more space in the trigger guard for people with sausage fingers

I didn't do it with a turned brass piece like the link suggests, i used a small square cut off from an old knackered nectar points card and glued it to the underside of the trigger that rests on the stop pin circled in the pic below. This sets back the trigger, and if it's too short a pull, just file off a bit of the plastic card til you get the desired result (i didn't get a pic of the actual mod i did, will do that tonight)

http://img.photobucket.com/albums/v3...ps2nqc8twc.jpg

I took plenty pics of the strip down, Here's one of the polished surfaces i did last night

http://img.photobucket.com/albums/v3...psz9c2du5x.jpg

[Twodoctors]

https://drive.google.com/file/d/0ByO...ew?usp=sharing

If you need a silencer for it, I can highly recommend the Hogan Decimeater. You'll need a 10mm to UHF adaptor as well.

Adrian

[davethepitch]

Is this translation page i have used any use to anyone regarding this Polish website https://translate.google.com/transla...p1_5_5_mm.html

Dave

[hawkeye]

https://drive.google.com/file/d/0ByO...ew?usp=sharing

If you need a silencer for it, I can highly recommend the Hogan Decimeater. You'll need a 10mm to UHF adaptor as well.

Adrian

Where best to get the unf adapter from ?
They are mostly 1/2" unc aren't they

[Twodoctors]

Where best to get the unf adapter from ?
They are mostly 1/2" unc aren't they

Most RFD sells them. As mentioned it needs to fit a 10mm barrel. 1/2" refers to the screw thread. Got mine for £4.50ish from NM Products in Sheffield.

Adrian

[richierich]

Most RFD sells them. As mentioned it needs to fit a 10mm barrel. 1/2" refers to the screw thread. Got mine for £4.50ish from NM Products in Sheffield.

Adrian

Got mine from JSR. £6odd

[hawkeye]

Got mine from JSR. £6odd

How do you get round fitting with foresight , does it have to be removed ?

[richierich]

How do you get round fitting with foresight , does it have to be removed ?

I'm going to make one so i can utilize the grub screw thread on the adapter, either that or drill and tap the front sight peice for 1/2" UNF and buy another adapter male-to-male so it can be unscrewed if required