Your perfect sporting breakbarrel?

[NickG]

I could be very wide of the mark here, mate - but isn't the rod in a 95 nigh on impossible to remove?

Yes wide Craig, the cross pin is in a blind hole, correct that and knock the pin out, the latch rod can then be punched out, if you then make the new one from 10 mm diameter silver steel, the piston can be reamed to take the new rod , drilled reamed and cross pinned back in . The new rod has to be sized for the trigger block hole or vica versa Not as easy as a tx .

[Craig-P]

Yes wide Craig, the cross pin is in a blind hole, correct that and knock the pin out, the latch rod can then be punched out, if you then make the new one from 10 mm diameter silver steel, the piston can be reamed to take the new rod , drilled reamed and cross pinned back in . The new rod has to be sized for the trigger block hole or vica versa Not as easy as a tx .

Thank you, mate. I knew I'd heard something about it not being quite straightforward.

[TonyL]

Yes, brilliant information, Nick; thank you.

Beyond the remit of most of us lowly tinkerers, but entirely do-able for the likes of you airgun engineering Demi-Gods such as your good self, Jon, Mick, Jim and a few others........

Might help facilitate a certain little project, Craigy?