You will have to tackle the anti tamper but also a cross pin under the plastic pellet trough and if it is glued in you
cannot use any heat as the plastic pellet trough MELTS!
Anybody know how to separate the breach block/barrel assembly from the air cylinder?
Mine is an early one without the threaded barrel for attaching a moderator and I want to machine the barrel.
Air Arms HFT 500. HW100 FSB. HW99 (.22) HW99 (.177) HW30 (.177) HW97K (.177) Gamo GX40 (.22)
You will have to tackle the anti tamper but also a cross pin under the plastic pellet trough and if it is glued in you
cannot use any heat as the plastic pellet trough MELTS!
As above - be warned, I have seen the procedure go very wrong indeed!