Well done, looks pretty good to me, & should be easy to spot if you drop it.
Well done, looks pretty good to me, & should be easy to spot if you drop it.
There’s some 3D printed AA mags on the bay of evil, going for £20, I’m quite tempted.
38
AA S410K .22, BSA Supersport .22, HW40 .177, Umarex Berretta 92fs .177 Webley Junior .177 (1954)
Going to make a few of these in .177 and .22 Probably ready mid next week
If anybody wants one to test, a SAE is all thats req....
They will be printed in odd colours like red, white blue, green etc and some may be luminous as I finish off end of filament spools of ABS and PLA
Hello, would test a 110 in 22 if you make any, also some 8 shot mags for a FX Verminator MK1 , cheers
Happy to test one in my HW100 in whatever colour they come in 🙂
Please PM me your address to send an SAE to.
Cheers Rich
WANTED: Next weeks winning lottery numbers :-)
I'll gladly try one out in my .22 hw100
Pm me your address details so I can send a sae
Right
After much faffing about, I've done 10 mags. 5 in .177 and 5 in .22
.22 are green, .177 are black
All printed in PLA + The other filaments just didnt cut it.
So if you want one, SAE a Large Letter priced jiffy or summut.
PM me for addy
These are supplied "as is"
So no moaning...
I'm not interested in selling these.
All I ask for is an honest review on accurate cycling and accuracy after they are loaded into the breech
[IMG][/IMG]
[IMG][/IMG]
PS If anyone has contact with Musclefox, aka Caesars Ghost tell him to answer his PMs....
I always wanted a Jonny Seven but santa never brought me one.
Perhaps that why I try to compensate with air rifles.
Repariere nicht, was nicht kaputtist.
Never had any issues with luminous, other than it's poor lume what CF filament have you had good results with, I'm yet to try it, after about 4yrs of 3D printing! I've upgraded to MicroSwiss hot ends, so have no issues with abrasive filament, just always thought the CF was too expensive to try on a whim.
they look good