if you know anyone with a good drill press and a drill vice they should be able to drill it out for you
sometimes they come out with a reverse cut drill bit others an easy out has to be used
the coking bolt screw sheared off ive been trying to remove it with no luck any ideas. i have another screw, wondered if anyone has the propper gear to remove it, i could pay you and send it in post, thanks for any replys
https://ibb.co/0c6YB99
https://ibb.co/bPd51m1
if you know anyone with a good drill press and a drill vice they should be able to drill it out for you
sometimes they come out with a reverse cut drill bit others an easy out has to be used
Is the screw hole all the way through?
Just wondered if you can persuade it to screw through & out the other side instead of "unscrewing" it?
ive tried reverse drilling, but now it wont move, i have a dremmell and normal drill, but the screw is very hard metal, i had it moving then it stuck. ill try again with drill. most likely ive drilled the threads out.
did you warm it first incase a wally loctited it
the hole is all the way through and the last i did i used a normal drill from the rear and it screwed straight out just as the drill bit coming out of the snapped side
i've just this minute done two cp2 bolt handles that had snapped off by this method as well
i tried, drilling it from the reari had it moving then it would not budge so tried drilling it out snapped two drill bits trying as its hardened steel bolt. like this on both sides
https://ibb.co/7KdRc48
this is my baby.
https://ibb.co/ZHnctq9
https://ibb.co/871r6tJ
Last edited by pistolnut; 01-04-2022 at 05:18 PM.
i found an old bolt from an e9a which had the tip broken off , tried that and it worked to my surprise.the pellet does not even go past the transfer port ,its before it and it still fires full power. ?
https://ibb.co/QYwSY3J
https://ibb.co/p49TsQD