Hw100 pellet probe seal

[duomatic410]

Having a nightmare trying to put one in.
Tried it more ways than the Karma Sutra and got older.
Any tips Gents.

[deejayuu]

Cleaning rod with no attachment from muzzle end and a piece of 4.5/5.5 rod from breech. Knitting needles are good source. Sandwich between them

[duomatic410]

Have resealed it, and been trying to fit just with face plate, tried with pellet pushed past seal groove, various types of tools etc but no joy.

[jcooper]

remove air cylinder, remove barrel, split the 2 halves, remove breech block. use cleaning pellet pushed up near groove in block.

fit new oring. remove cleaning pellet. fit new 12 x 1 oring to breech block. connect both halves. refit barrel (check serial number on left). refit cylinder.

this is the quickest way to do it.

[duomatic410]

remove air cylinder, remove barrel, split the 2 halves, remove breech block. use cleaning pellet pushed up near groove in block.

fit new oring. remove cleaning pellet. fit new 12 x 1 oring to breech block. connect both halves. refit barrel (check serial number on left). refit cylinder.

this is the quickest way to do it.

Have stripped and re sealed, this is with just probe face plate so should be a doddle, have done them in the past, seals right according to diagrams will sleep on it🙄

[duomatic410]

Sorted.
It was easy really, once I took the old seal outI had probed with tool but couldnt feel one and as it was blowing that bad assumed it was out.
Anyway it's up and running nice.

[chris.e]

Sorted.
It was easy really, once I took the old seal outldeek

And I was sympathising with you thinking 'that sounds a bit of a mare.' That's funny.

[duomatic410]

And I was sympathising with you thinking 'that sounds a bit of a mare.' That's funny.

Need sympathy with the hearing Chris, but as Benny Hill used to say, learning all the time, but not on this subject..

Onwards and upwards.

[chris.e]

Your not on your own, bud. I'm the same. I keep being told 'I'm at a funny age.'