Reply With QuoteThe best bet is to measure your existing spring or spring guide and I.d of the piston and get one that suits best, I'm not sure what platform they're based on but I'm think maybe similar to a gamo 440 so that could be a good place to start bud.
Registered User
Hi everyone, I have a beeman rs3 that currently shoots at 8ftlb in 177.I dont have the 22 barrel but would like to get it closer to 12 ftlb. The seals good and it's lubed properly so i need an upgraded sring. Any ideas where i may get one. Thanks in advance
Nec aspera terrent
HW77k, Dan Wesson 6mm, baikal makerov MP645k
Registered User
The best bet is to measure your existing spring or spring guide and I.d of the piston and get one that suits best, I'm not sure what platform they're based on but I'm think maybe similar to a gamo 440 so that could be a good place to start bud.
Registered User
From a google picture search, they seem to be based on the same Norica model which the SAG AR1000 was modeled after.Originally Posted by mattyw1987
They need a quite slim spring if they are fit with the heavy steel piston sleeve.
Too many airguns!
Registered User
Have you tried adding pre load washer(s) first?
Registered User
Yep, just one washer stops the gun from cocking properly. Cheers though.
Nec aspera terrent
HW77k, Dan Wesson 6mm, baikal makerov MP645k
Registered User
Thanks for the info guys, its appreciated
Nec aspera terrent
HW77k, Dan Wesson 6mm, baikal makerov MP645k
Registered User
Can you say specs. for existing spring please? length x OD x wire thickness x number of coils x rate
May have something to suit
P.S. what pellet gave 8 fpe?
Last edited by deejayuu; 04-07-2022 at 08:39 PM.
Posting Permissions